DeviceNet Remote Modules

1 Port DeviceNet Master Module with dual port RAM

● 3 indication LEDs (Error,Status,Bus LEDs)
● Programmable Master MAC ID
● Programmable transfer-rate 125K, 250K, 500K
● Support maximum nodes up to 64
● Support Group 2 and UCMM functions
● The maximum Fragment number is (Input/Output) up to 64
● Support I/O Operation Mode: Poll, Bit-Strobe and Change Of State/Cyclic
● Support Auto-scan slave device function
● Support on-line add device into and remove device from network
● Support Auto-Reconnect when the connection is broken

1 Port DeviceNet Master Slot Module

● 3 indication LEDs (Error,Status,Bus LEDs)
● 1 KVdc isolation on CAN side
● Programmable Master MAC ID
● Programmable transfer-rate 125 K, 250 K, 500 K
● Support maximum nodes up to 64
● Support Group 2 Only Server functions
● The maximum Fragment number is (Input/Output) up to 64
● Support I/O Operation Mode: Poll, Bit-Strobe and Change Of State/Cyclic
● Support Auto-scan slave device function
● Support on-line add device into and remove device from network

CAN bus Remote I/O module with CANopen Protocol of 8-Channel PWM and 8-Channel High Speed Counter

● Hardware-controlled PWM output
● PWM output frequency: 0.2 Hz ~ 500 kHz with 0.1%~99.9% duty cycle
● PWM Output Modes: software trigger / hardware trigger
● Trigger each PWM output individually or all PWM outputs synchronously
● Support Burst output mode and Continue output mode
● Provide 32-bit 500 kHz high-speed counter for each DI channel
● Pass the validation of DeviceNet conformance test
● Provide EDS file for DeviceNet master interface