Wij gebruiken cookies om uw ervaring beter te maken. Om te voldoen aan de cookie wetgeving, vragen we uw toestemming om de cookies te plaatsen. Meer informatie.
CWE Amplifier Head Stage ISO-Z
Levertijd:
3~4 weken
SKU
ISO-Z
Isolated Amplifier Head Stage
● Provides Medical-Grade Isolation for The BMA-931
● Built-In Calibration Signal
● Provides An Additional Gain Stage of x10
● Supplied With a Long Interconnecting Cable that Allows Head-Stage Location at the Signal Source
The ISO-Z is a low noise, high impedance amplifier head-stage. It's designed to plug into the BMA-931 Bioamplifier Module for applications where it's necessary or desirable to isolate the subject from the data acquisition system. It uses a medical-grade isolation amplifier to isolate the input connections from chassis or earth grounds. The ISO-Z supplies both gain and calibration, further enhancing its performance. The low impedance output of the ISO-Z is able to drive long cables, making it ideal for use in applications where the DI-1000 Series chassis must be located at a distance from the recording site.
Meer informatie
Art.nr.
ISO-Z
Fabrikant
CWE
Land van herkomst
Verenigde Staten
Specifications
| Input Type | Differential, balanced to chassis common | ||||
| Input Range | ±600 mV | ||||
| Impedance | >1010 Ω differential | ||||
| Wideband Noise, RTI | <12 μv P-P, <4 μv rms | ||||
| Common Mode Rejection | >110 db @ 60 Hz | ||||
| Gain Range | 10x | ||||
| Frequency Response | DC-8 KHz | ||||
| Input Connector | Pin jacks; .080 inch diameter | ||||
| Output Range | ±6 V | ||||
| Output Connector (Rear Panel) | Amphenol, 7-pin plug | ||||
| Isolation Voltage |
|
||||
| Leakage Current (Input to GND) | <5μa | ||||
| Calibrator Voltages | 500 μv , 10 Hz square wave |
Power Requirements
±12 VDC @20 mA from BMA-931
Size (W x H x D)
88.9 x 30.5 x 109.2 mm