ICPDAS STEP-200

Levertijd:

2~7 dagen

SKU

STEP-200

2-axis, High-speed Stepper Motor Controller

● 2-axis independent, simultaneous stepper motor control/servo motor control (pulse input type)
● DOS, windows 95, windows NT driver
● Embedded Micro-processor
● Command type interface
● Linear, circular interpolation
● Automatic trapezoidal acceleration/deceleration
● Output polarity can be programmable
● 5 optical isolated digital inputs per axis for limit switches

Details

STEPPER-200 is a plug-in, 2-axis, command-based stepper motor controller board for the IBM PC/XT/AT and compatibles. It also can be used in pulse-type servo motor control (pulse input type). This board has an μP build-in . ThisμP perform variety of motion control commands itself and share the loading of host computer .

A 2Kbytes-FIFO is introduced as a command buffer. This buffer can provide 1360ms buffer time. Therefore the hardware architecture of STEP 200 is good for windows operation system. The STEP 200 will provide DOS, Windows 95 and Windows NT driver. It can offer real time motion control solution in windows system.

SOFTWARE:

● Toolkit for DOS
● Toolkit for Windows 95/98
● Toolkit for Windows NT
● Toolkit for Windows 2000/XP
● Toolkit for LabVIEW 2000/XP
● Toolkit for LabVIEW NT
● Toolkit for LabVIEW 95/98
● Driver for LINUX

SPECIFICATIES

Meer informatie

Art.nr.

STEP-200

Fabrikant

ICPDAS

Algemeen

● Step rate: 1pps~250Kpps

● Max. step count: ±2.32 −1 steps

● Output pulse modes: CW/CCW or pulse/direction

● 2500Vrms optical isolated signal output

● 5 optical isolated digital inputs per axis for limit switches

● Power Requirements: +5V mA typical , mA max.

● Operating Temperature: 0 °C ~ +50 °C

● Storage Temperature: -200 °C ~ +70 °C

● Power Requirements: +5V@ 500mA typical

● Dimension: 108 x 167mm

Stel uw vraag

ICPDAS STEP-200

Laatste nieuws