Wij gebruiken cookies om uw ervaring beter te maken. Om te voldoen aan de cookie wetgeving, vragen we uw toestemming om de cookies te plaatsen. Meer informatie.
ICPDAS SERVO-300
3-Axis V-command Servo motor board
● 3-axis V-command servo motor board
● Simulation / open loop / close loop mode
● Command-type execution, 49 commands
● Embedded CPU
● Linear interpolation, circular interpolation
● Programmable trapezoidal speed profile
● Programmable DDA cycle
● Programmable direction configuration
● Programmable 2 speed home return, home preset
● 2500 points per axis pitch error compensation
● Home, forward, backward limit switches per axis
● Limit switch auto-protection
● Hardware failure detection
● 8 digital input, 7 digital output
● Software / hardware emergency stop
● 2500Vrms optical couple
● DOS, Windows 95, Windows NT driver
● BCB, VB, Delphi, LabView driver
● Programmable limit switch normal state: N.O. (normal open) or N.C. (normal close)
Servo-300 is a 3-axis, command-type, servo motor control board. The embedded CPU of servo-300 performs the motion command transferred from host-PC via a 2K bytes FIFO. It also sends the position and status to host-PC via another 2K bytes FIFO.
This buffer provides time buffer and it is very suitable for windows operating system. This board provides DOS, windows 95 and windows NT drivers.
SOFTWARE:
● Toolkit for Windows 95/98
● Toolkit for Windows NT
● Toolkit for Windows 2000/XP
● Toolkit for LabVIEW 2000/XP
● Toolkit for LabVIEW NT
● Toolkit for LabVIEW 95/98
● Driver for LINUX
● The Operating Mode
● Simulation Mode
● Open Loop Mode
● Close Loop Mode
● The Control System